Máy kéo nén lò xo
- High accuracy
- Low forces
- Certifcate of calibration included
- Record force and deflection
- Máy thử lò xo
Máy kéo nén lò xoMáy thử kéo nén lò xoMáy đo lực kéo nén lò xo ANDILOGMáy thử mỏi lò xo
Thiết bị thử kéo nén ANDILOG
Exact positioning
The force tester Springtest 2 is dedicated to high precision measurements of compression, especially to springs. It is robust and equipped with a small crank handle which enables a precise and easy positioning of the measuring head on the spring. This test stand is also equipped with a precise displacement sensor which gives a measurement of the flexion or height measured under load with a resolution of 5 µm.
In order to ensure the perfect parallelism during the measurements, the under platen of the Springtest is adjustable. This improves the positioning of the spring or the component and guarantees a compression with very less mechanical noises. On demand, Andilog can also develop a mechanical guide for your springs.
Sensor protected again overloads
The Springtest 2 is equipped with a set of adjustable limit stops and with strain gauges of high precision (0,1% FS). This makes sure that the maximal capacity of the load cell is not exceeded. These stops are adjustable manually.
The crank handle permit the slow and exact positioning of the measuring head: a full rotation with the handle corresponds to a vertical displacement of 2,54 mm (0,1 in).
Data acquisition software Caligraph
During the measurement, the Springtest 2 shows on the included data acquisition and analyzing software Caligraph the force/time or force/displacement curve. This data is saved automatically on your computer and Caligraph enables you to analyze, format and export the test results into personalized reports. Of course, you can also export the points of the curve into Excel.
The Springtest 2 is the perfect solution for repeatable, precise and traceable force and displacement measurements for your springs and components. Bauteile.
